Posts Tagged ‘Modifications’
Walkera CB180Q RC Heli Indoor Flight after modifications
Another indoor flight of the Walkera CB180Q helicopter after some modifications.
Video Rating: / 5
Related
Double Horse 9104 RC helicopter review, modifications, mods first time setup
The Double Horse 9104 RC helicopter is only 550mm prolonged, and is not 710mm extended as mentioned on the box. It did not fly forward with out modifications but the mods are straightforward sufficient to do from residence and this helicopter is more quickly and a lot more enjoyable and tough to fly than the smaller sized SYMA indoor RC I have. Acquire right here – www.ebay.co.british isles Clay – www.ebay.co.united kingdom
Online video Ranking: four / 5
Related
Double Horse 9104 RC helicopter review, modifications, and comparison to Volitation 9053
The Ambigu Horse 9104 RC helicopter fuselage is only 550mm prolonged, and is not 710mm lengthy as mentioned on the box. It did not fly forward with out modification. Nonetheless, the modifications are effortless and this helicopter is faster and more entertaining and challenging to fly than the Volitation 9053.
Video clip Rating: four / five
Related
Walkera 38# CH46 RC Helicopter. Modifications and tips
A video diary of the modifications made to this fascinating RC Electric helicopter. The video is presented in a ‘how to style’ but you modify at your own risk! That said I am very pleased with the results. Another note of caution! as the controls are now much more fierce, go steady when flying! this is not a stunt heli LOL OK May 2009 I have discovered that only one rotor set needs to be in charge! if both are the same they cancel out. Check the thread on the RC Forum here. www.rcgroups.com Then taking the advice here regarding keeping one rotor set almost unmoved I set about making the front set the ones that have nearly all the fore and aft control. The rear set just twitches a bit now where as the front set swash moves very clearly! I also biased the front swash forwards! so that you can actually see it when at rest. This I did by moving the puller rod to one of the outer positions of the servo wheel. Initial tests show I now have a hoverable heli that goes forward when asked even in a light wind
Video Rating: 0 / 5
Related
