AR7000 heli channel setup
Quick 4 to 5 minute run down on how ot connect your heli servos to your Spektrum type receiver.
TIP: Remember to set up your Gyro on your Gear Channel in your TX
I Did this because I stupidly … ripped all my cables out when an AR6200 failed on me …… and I did not take any notice on how all the cables went into the receiver. Hope this helps.
Related
7 Responses to “AR7000 heli channel setup”
Leave a Reply
Custom Search
Hello West y, i have a 450 trex but o ley helicópter without reciben, what u recomend to get to make it work, i also have an spektrum dx7, thanks.
Hello is there any compatible receiver with my M1 Hurricane controller
Hey can you tell me where all of these channels? Like the pitch goes to the 6th channel where does the rest go? In numbers
Excellent thanks
hey mate whats your number? im assuming west auckland? i need some help with my align 600 flybarless setup cheers mate
I HAVE A TREX 600 WITH A SEPRATE BATTERY POWERED ALIGN BEC WHERE DOES IT PLUG IN ON THE AR7000? IF IT PLUGS IN WHERE THE BIND PORT IS, THEN HOW DO YOU BIND THE HELI TO THE RADIO?
Gee Thanks ….. nice solid hover takes a lot of concentration …. I find that I start wandering and that is when I am losing concentration. if you put it down and start again … the challenge begins again! it is all about you disciplining the mind to control what you are doing … not the other way around.