Exi 450 T-rex clone rc helicopter flight
My new exi 450 flown with mostly belt cp electronics, including belt cp radio, reciever, rate gyro, 2 8g seros, and motor with 11t pinion
Video Rating: 5 / 5
Related
3 Responses to “Exi 450 T-rex clone rc helicopter flight”
Leave a Reply
Custom Search
Try flipping that idle up switch with the throttle at a little less than 1/2 and see if you can hear a change in RPM. If you flip the switch at something MORE than 1/2 throttle then you won’t hear a change because the idle up throttle and pitch curve is the same as the normal mode. I know this might sound confusing so I’ll send you a private message with a link that will help illustrate this.
The only servo I had to reverse was the elevator servo, but only because it was a hitec servo, not an esky servo. I even had to reverse that servo on my belt cp. Well about the motor, for a couple seconds I switched into idle up and no difference. It is possible that it might be going to full speed in normal mode, and thats why theres no difference between the two. I’ll make more shortly, Hopefully I can get one of my lazy brothers to film me!
GOOD JOB. That’s so awesome you got it to work with the BeltCP electronics! Did you just reverse all the servos on the swash plate? It sounds like your motor is getting to full speed. How do you know it’s not? Good flying too. You look pretty relaxed and confident even doing the node in hover! Can’t wait to see more videos of your with the hat cam.